Given the lower system head the intersection of the h q curve with the system head curve is out towards the right end of the h q curve at or near runout.
Well pump head pressure.
This is because the pump must use energy to bring the water to the level of the pump.
The discharge pressure of the pump should be approximately equivalent to the total dynamic head tdh required by the system tanks pipes elbows valves flanges and fittings.
The relationship between head and pressure can be characterized by the following formula.
The pressure at the discharge of the pump however will be higher for the heavier solution.
This is because the water entering the pump applies additional pressure at the suction.
Considering the thermal regime in the study area calculations indicate a pressure loss of about 4 2 bar since a well head pressure whp of about 15 8 103 kpa during the oxidizer injection and of 3 6 bar taking into account the ucg operation at slightly sub hydrostatic pressure in the target coal seam which is expected to be in an acceptable range for the chosen liner diameters and well dimensions.
Total dynamic head tdh.
If the water level is higher than the pump then the suction head is negative and pump head will increase.
A direct driven sprinkler system.
To monitor and control your pump your pump should have a suction pressure gauge and a discharge pressure gauge installed on the pump.
The average pressure in a domestic water system with a pressure tank used.
When a pump is started up with an open valve there is initially little system head pressure acting in opposition to the pump head capacity curve.
Where p pressure psi h head ft.
Conversely if the pump is located above the water to be pumped then the suction head is positive and the pump head will decrease.