With this method you are going to tuck the edge of the carpet into the z bar and then fold it over itself.
Ways to install carpet with z bar.
Once stretched trim the carpet 1 inch past the edge of the tile.
Cut the z bar to this.
Next unroll the carpet padding from one side of the room to the other and slice it off with a box cutter.
Some are held in position by.
Cut the padding underneath the carpet back to the point of where the z bar will start.
The z bar will then screw down into the sub floor and hold the carpet in place.
Start in the corner of the room furthest from the door way and work your way toward the door.
To install carpet start by nailing the tack strips to the floor using 2 nails for each strip.
That way the carpet is already tucked in and you re just adding an extra level of security.
Bring the carpet up to the transition point and measure 1 extra inch.
Next place the carpet over the z bar and the tack strip and use the carpet kicker to stretch the carpet.
The z bar needs to be able to lay.
How to install a z bar carpet strip step 1.
Cut the z bar to fit using a hacksaw.
Read your z bar instructions carefully to ascertain how it is fixed to the floor.
A special tool called a z bar enables you to install lengths of carpet in doorways so that they fit perfectly.
Hammer the z bar down by placing the tack bar on top of the edge and hammering to the floor.
Cut off the corners of the z bar where the door jamb will be with tin snips.
Mount tack strips to sub floor.
Pull the padding only and place over the installed tack strip trim the padding with the edge of the tack strip keeping your hand on the angle away from the nails.
Simply put this transition bar has the form of the z letter to ensure that the carpet s edge is tucked under the tile.
When you do this you are going to be able to run the carpet directly up to the edge of the tile.
Once the padding is in place staple it down every 2 feet and duct tape the seams together.
Measure the opening of the doorway or entryway where you will be installing the z bar.
How to fold carpet when laying next to ceramic tile flooring 1.
Use the carpet cutter tool to cut the carpet a few inches longer and wider than the length and width of the room and then roll the carpet inward for easier installation.
Learn how to use a z bar in this free video on carpet cleaning and installation.
Fold the carpet over on the edge and using your knee kicker stretch the carpet to the z bar.